Design and application of squeeze film dampers for turbomachinery stabilization

The steady-state transient response of the squeeze film damper bearing was investigated. Both the steady-state and transient equations for the hydrodynamic bearing forces are derived; the steady-state equations were used to determine the damper equivalent stiffness and damping coefficients. These coefficients are used to find the damper configuration which will provide the optimum support characteristics based on a stability analysis of the rotor-bearing system. The effects of end seals and cavitated fluid film are included. The transient analysis of rotor-bearing systems was conducted by coupling the damping and rotor equations and integrating forward in time. The effects of unbalance, cavitation, and retainer springs are included. Methods of determining the stability of a rotor-bearing system under the influence of aerodynamic forces and internal shaft friction are discussed

A magnetic damper for first mode vibration reduction in multimass flexible rotors

Many rotating machines such as compressors, turbines and pumps have long thin shafts with resulting vibration problems, and would benefit from additional damping near the center of the shaft. Magnetic dampers have the potential to be employed in these machines because they can operate in the working fluid environment unlike conventional bearings. An experimental test rig is described which was set up with a long thin shaft and several masses to represent a flexible shaft machine. An active magnetic damper was placed in three locations: near the midspan, near one end disk, and close to the bearing. With typical control parameter settings, the midspan location reduced the first mode vibration 82 percent, the disk location reduced it 75 percent and the bearing location attained a 74 percent reduction. Magnetic damper stiffness and damping values used to obtain these reductions were only a few percent of the bearing stiffness and damping values. A theoretical model of both the rotor and the damper was developed and compared to the measured results. The agreement was good

Analysis of Pt/SnO(sub x) during catalysis of CO oxidation

Temperature-programmed reduction using 6kPaH2 suggests that a sample consisting of 3 percent Pt supported directly on SnO2 is, under conditions of catalysis of CO oxidation used here, best represented as 3 percent Pt/SnO sub x, since the support is likely to partially reduced, probably in the vicinity of the metal/oxide interface. Catalytic measurements at 421 to 424 K show that this 3 percent Pt/SnO sub x is significantly more active per unit area of Pt than 6 percent Pt/SiO2 in catalyzing the oxidation of CO. In situ micro-FTIR reveals that while the latter has predominantly linearly bound CO on the surface under reaction conditions, the Pt/SnO sub x also has a species absorbing at 2168 cm(exp -1) which may be CO upon Pt in a positive oxidation state or weakly chemisorbed CO on zero-valent Pt. This may be directly involved in the low temperature oxidation of CO on the Pt/SnO sub x, since being weakly held the activation energy for its surface diffusion to the metal/oxide interface will be low; such mobile species could allow the high rates of surface transport and an increase in the fraction of the surface over which the CO oxidation occurs. FTIR also reveals carbonate-type species on the P/SnO sub c surface

Genotypic status of the TbAT1/P2 adenosine transporter of Trypanosoma brucei gambiense isolates from northwestern Uganda following melarsoprol withdrawal

Human African trypanosomiasis (HAT) manifests as a chronic infection caused by <i>Trypanosoma brucei gambiense</i>, or as a more acute form due to <i>T. b. rhodesiense</i>. Both manifestations occur in Uganda and melarsoprol use against the former was jeopardised in the 1990s as reports of reduced efficacy increased to the point where it was dismissed as first-line treatment at some treatment centers. Previous work to elucidate possible mechanisms leading to melarsoprol resistance pointed to a P2 type adenosine transporter known to mediate melarsoprol uptake and previously shown to be mutated in significant numbers of patients not responding to the drug. Our present findings indicate that there is a low prevalence of mutants in foci where melarsoprol relapses are infrequent. In addition we observe that at the Omugo focus where the drug was withdrawn as first line over 6 years ago, the mutant alleles have disappeared, suggesting that drug pressure is responsible for fuelling their spread. Thus constant monitoring for mutants could play a key role in cost-effective HAT management by identifying which foci can still use the less logistically demanding melarsoprol as opposed to the alternative drug eflornithine. What is required now is a simple method for identifying such mutants at the point of care, enabling practitioners to make informed prescriptions at first diagnosis

Development of the Motivational Interviewing Supervision and Training Scale

The movement to use empirically supported treatments has increased the need for researchers and supervisors to evaluate therapists’ adherence to and the quality with which they implement those interventions. Few empirically supported approaches exist for providing these types of evaluations. This is also true for motivational interviewing, an empirically supported intervention important in the addictions field. This study describes the development and psychometric evaluation of the Motivational Interviewing Supervision and Training Scale (MISTS), a measure intended for use in training and supervising therapists implementing motivational interviewing. Satisfactory interrater reliability was found (generalizability coefficient p2 = .79), and evidence was found supporting the convergent and discriminant validity of the MISTS. Recommendations for refinement of the measure and future research are discussed